NEC Electra Elite IPK Programming Manual page 451

Document Revision 4
___________________________________________________________________________________
1-15-20 Centralized 911/Calling Party (CPN)
Originating Number Selection
General Description
Use this Memory Block to assign the Electra Elite IPK installed as a Remote K-CCIS
Office to send the Station Number or CES-ID or Calling Party Number for Calling Party
Number information to the Main Office when an Emergency 911 call is originated.
This Memory Block is used at remote offices only.
R2000 or higher is required.
Display
D a t a
N o .
2 0 : 9 1 1
T I M E
Settings
LK 1 LK 2
STA.
CESID
(Station
(CES-ID)
No.)
Programming Procedures
1 Go off-line.
B K
2 Press LK1 + LK15 +
3 Press the corresponding CO/PBX line key to change the Setting Data option.
G
4 Press to write the data, and display the next Memory Block.
5 Program the next Memory Block or press
Related Programming
M.B. Number Memory Block Name
1-8-43
Enhanced 911 Trunk Assignment
1-8-44 Enhanced 911 Alternate Route Assignment
1-8-45 Enhanced 911 Alternate Route Assignment (Maintenance Busy)
1-8-46 Enhanced 911 Dialing Digit Assignment
1-15-19 Centralized 911 Allow/Deny Selection
1-15-21 Centralized 911 Look Ahead Routing Allow/Deny Selection
___________________________________________________________________________________
2 - 374
S e t t i n g
T i t l e D a t a
O R G S T A .
D I S P L A Y
LK 3 LK 4 LK 5
to access the Memory Block.
E
to go back on-line.
LK 6 LK 7 LK 8
Electra Elite IPK
System Mode
1
Submode
15
Data No.
20
PC Programming
+AW
The shaded
selection is the
default.
Memory Blocks