NEC Electra Elite IPK Programming Manual page 773

Document Revision 4
___________________________________________________________________________________
___________________________________________________________________________________
3 - 50
• When incoming and outgoing calls are processed simultaneously
the incoming call has priority. A collision error between
simultaneous SETUP messages is generated, and the outgoing
call gets a busy signal.
The Incoming/outgoing (IC/OG) SFG must be equal to or greater than
the outgoing (OG) SFG. When not, In many cases, the Electra Elite
system does not accept an incoming call.
When Operator Call Time Out Table is set to 0 in LCR Programming, the
operator call requiring more than 1 digit cannot be used. When 0 + any
digits is stored in speed dial, the system sends the call as 0 Call
(operator) only.
Electra Elite IPK
Advanced Applications