Document Revision 4
___________________________________________________________________________________
2.1
___________________________________________________________________________________
1 - 2
New Installation
Develop System
Data Sheet
Installation
Test System with Default
Values
System Data
Programming (Note 1)
TEST
Note 1: For new installation, system default values are assigned when power is
turned on. Program the system data to be changed only.
Note 2: For component replacement, program the relevant system data.
Note 3: For function change, program the system data to be revised.
Figure 1-1 Programming Flowchart
Features of Programming
The following features are provided with Multiline Programming:
The system operates from default after initial power-up. Only the
parameters that change must be programmed.
System programming characters are displayed on the LCD of the
Multiline Terminal.
Several types of system programming can be entered at the same time.
Data programmed for one telephone (e.g., Tenant Mode, or Telephone
Mode) can be copied to another telephone.
Existing System
Component
Replacement
Rewrite System
Data Sheet
Installation
System Data
Programming (Note 2)
TEST
Multiline Terminal Programming
Electra Elite IPK
Function
Change
Rewrite System
Data Sheet
System Data
Programming (Note 3)
TEST