NEC Electra Elite IPK Programming Manual page 668

Electra Elite IPK
___________________________________________________________________________________
1. Telephone Ports A0~C0 are ports 100~120.
2. The name can be entered using the dial pad. Follow the procedures in Appendix B Character Codes.
3. The default names listed in the table below are assigned based on the line key type from Memory Block 4-12
(Line Key Selection for Telephone Mode).
LK Assign
NON (not assigned)
CO Outside Lines
Call Forward – Busy/No Answer
Call Forward – All Calls
Call Appearance Keys (CAP)
Programmable One-Touch Keys
Trunk Group
Route Advance Group
SIE including CAR
Microphone
Headset On/Off Key
Scroll Key for Caller ID indication
Do Not Disturb On/Off
Log On/Off
BGM On/Off
Intercom Key
___________________________________________________________________________________
Programming Manual
Notes
Default
All Blank
CO^xx xx=Port 01~64
CFB
CFA
xx=Block 00~47
CAPxx-yy
yy=Key 01~24
FA xx xx=key 01~24
TKGP^xx xx=Trunk Group 01~32
ADV^xx xx=Group 01~16
SIE^xxx xxx=Port No. 01~99, AO~CO
MIC
HSET
SCROLL
DND
LOG
BGM
ICM
Note
Document Revision 4
2 - 591