Trunk (Installed, Dp/Dtmf) Selection - NEC Electra Elite IPK Programming Manual

Document Revision 4
___________________________________________________________________________________
3-92 Trunk (Installed, DP/DTMF)
Selection
General Description
Use this Memory Block to specify an external line as DP (10 pps or 20 pps), DTMF
line, or not connected (NIL).
Display
C O / P B X
D a t a
N o .
N o .
( 0 1 ~ 6 4 )
0 1 / 9 2 : M F
T I M E
Settings
LK 1 LK 2
NIL DP 10pps
Programming Procedures
G
1 Go off-line.
2 Press LK3 +
3 Press line key to specify external line as DP or DTMF for CO/PBX No.
Use the following to enter data:
J
t o move the cursor left
L
t o move the cursor right
K I
~ t o enter numeric data or CO/PBX No.
D
– OR –
G
to go to the next assigned CO/PBX No.
4 Press to write the selected data and display the next CO/PBX No. for Memory Block 3-90. After CO/PBX No. 64 is
entered, CO/PBX No. 01 is again displayed on Memory Block 3-90.
Related Programming
M.B. Number Memory Block Name
3-14 Tie Line Type Assignment
4-12 Line Key Selection for Telephone Mode
Only Tie lines and Direct Inward Dialing (DID) trunks can use dial pulse on the Electra Elite system. All other
trunks must be set to multifrequency (MF).
___________________________________________________________________________________
2 - 500
S e t t i n g
D a t a
D I S P L A Y
LK 3 LK 4
DP 20pps MF
I B
+ to access the Memory Block.
LK 5 LK 6 LK 7
Notes
Electra Elite IPK
CO/PBX Line Mode
3
Submode
—
Data No.
92
PC Programming
+BCT
LK 8 The shaded
selection is the
default.
Memory Blocks