NEC Electra Elite IPK Programming Manual page 710

Electra Elite IPK
___________________________________________________________________________________
Table 2-2 Card Interface Slot Assignment (Continued)
ETU
VRS(4)-U( )
X Compatible
– Not Compatible
1 Cabinet 1 only
2 Cabinet 1, Slot 1 only of second, third, or fourth system
3 The VP/CTI (12)/(16)-U( ) ETU requires two physical slots.
4 The CTP(16) requires only one IF Slot.
1. ETU interface cards are assigned automatically during initial power up.
2. ESI(8)-U ETU with ports 01 and 02 cannot be changed.
( )
3. When ETU system capacity is exceeded, ERROR is displayed on the LCD, and the Transfer key cannot be used
to write data.
4. When changing an interface slot assignment to a different ETU, use the following procedure:
a. Remove the ETU installed in the slot.
Power off ACD(8), VoIP, VMS, IPCA, or FMS ETU before removing it.
b. Program the slot for new ETU in this Memory Block.
c. Install the new ETU.
5. VMS(2)/FMS(2)-U
( )
6. Eight BSU(2)-U ETUs can be installed in the EXP Electra Elite IPK. Only three can be installed in the Basic
( )
Electra Elite IPK.
7. Page 2, LK 5 is used for indication only. The VDH2(8)-U( ) ETU cannot be assigned.
8. Refer to Electra Elite IPK Features and Specifications Manual, Universal Slots, for maximum capacities.
9. When the SLIB(4)-U10 ETU is initially installed, pressing RESET may be necessary for proper functionality.
10. When the MG(8)-U( ) ETU is installed in a Basic Port Package, trunk ports 17~24 are dedicated for this ETU.
___________________________________________________________________________________
Programming Manual
Port Type
VRS
ETU must be assigned as a VMS(4)/FMS(4)-U
Slot Availability
ISA IF1, IF2
– X
Notes
ETU.
( )
Document Revision 4
IF3~IF8
X
2 - 633