NEC Electra Elite IPK Programming Manual page 354

Electra Elite IPK
___________________________________________________________________________________
1-10-07 Call by Call Service Parameter
Assignment
General Description
Use this Memory Block to specify the Service Parameters for each Route Advance
Block (RAB). This setting data is sent to the Service Parameters in the NSF-IE
(Network Specific Facility Code-Information Element) when making outgoing calls.
Service Parameter Assignment is an Identification Number that is assigned when
subscribing with the carrier for the different services.
Display
D a t a
R A B
N o .
0 1 ~ 3 2
0 1 / 0 7 : S P
T I M E
Programming Procedures
1 Go off-line.
J G
2 Press LK1 + LK10 +
3 Enter 1~5 digits for Setting Data using the dial pad.
Use the following to enter data:
J L
a nd
K I
D
~ t o enter data
to select next RAB No.
Setting Data No. 1 = 0 or 1 for each entry.
Setting Data No. 2 = Three-digit code 000~127 for each entry.
G
4 Press to write the data. Digit 2 is displayed.
5 Repeat Steps 3 and 4 for each remaining digit for RAB 1. The next Memory Block is displayed.
6 Program the next Memory Block or press
___________________________________________________________________________________
Programming Manual
S e t t i n g
S e t t i n g
T i t l e
1 ~ 5 D a t a 1
D a t a 2
1 = 0 – 0 0 0
D I S P L A Y
to access the Memory Block.
t o move the cursor
E
to go back on-line.
Document Revision 4
System Mode
Submode
Data No.
PC Programming
Default Values
All RABs 0~000
1
10
07
+AY
2 - 277