Co/Pbx Incoming Ringing Alarm Time Selection - NEC Electra Elite IPK Programming Manual

Electra Elite IPK
___________________________________________________________________________________
1-1-06 CO/PBX Incoming Ringing Alarm
Time Selection
General Description
Use this Memory Block to specify the time between when a CO/PBX call is detected
and the ringing tone changes to a higher pitch when the call is not answered. When
No Limit is selected, the ringing tone does not change.
This Memory Block can be adjusted in 1-second intervals (R3000 or higher).
Display (R2500 or lower)
D a t a
N o .
0 6 : R I N G
T I M E
Settings
LK 1 LK 2
10s 20s
Programming Procedures
1 Go off-line.
K F
2 Press LK1 + LK1 +
3 Press the corresponding CO/PBX line key to change the data option.
G
4 Press to write the data and display the next Memory Block.
5 Program the next Memory Block or press
Refer to the next page for R3000 or higher Programming Procedures.
___________________________________________________________________________________
Programming Manual
S e t t i n g
D a t a
T i t l e
∞
A L M
D I S P L A Y
LK 3 LK 4 LK 5
∞
30s
(No Limit)
to access the Memory Block.
E
to go back on-line.
LK 6 LK 7 LK 8
Document Revision 4
System Mode
1
Submode
1
Data No.
06
PC Programming
+BM
The shaded
selection is the
default.
2 - 11