Disconnect Recognition Time Selection - NEC Electra Elite IPK Programming Manual

Electra Elite IPK
___________________________________________________________________________________
3-33 Disconnect Recognition Time
Selection
General Description
Use this Memory Block to specify the minimum time before a disconnected circuit can
be accessed again.
Display
C O / P B X
N o . D a t a
( 0 1 ~ 6 4 ) N o .
0 1 / 3 3 : D I S T
T I M E
Settings
Page 1
LK 1 LK 2
0 0.1
Page 2
LK 1 LK 2
0.8 0.9
Programming Procedures
G
1 Go off-line.
2 Press LK3 + +
3 Press the corresponding CO/PBX line key to change disconnect recognition time for CO/PBX No.
Use the following to enter data:
J
t o move the cursor left
L
t o move the cursor right
K I
~ t o enter numeric data or CO/PBX No.
D
– OR –
C
to go to the next assigned CO/PBX No.
A
to go to the next page
G
to go to the previous page
4 Press to write the data and display the next Memory Block.
5 Program the next Memory Block or press
When a call origination on a CO/PBX line or Tie line is interrupted or dropped, and an attempt is made to seize
the line again, it must be disconnected and cleared before it can be accessed again.
___________________________________________________________________________________
Programming Manual
S e t t i n g
T i t l e
D a t a P a g e
0 . 3 | 1
D I S P L A Y
LK 3 LK 4
0.2 0.3
LK 3 LK 4
1.0 1.1
C C
to access the Memory Block.
E
to go back on-line.
LK 5 LK 6 LK 7
0.4 0.5 0.6
LK 5 LK 6 LK 7
1.2 1.3 1.4
Notes
Document Revision 4
CO/PBX Line Mode
3
Submode
—
Data No.
33
PC Programming
+BCT
LK 8
The shaded
0.7
selection is the
default. Times
LK 8
are in seconds.
1.5
2 - 467