1-16-17 Back Pressure For Half Duplex - NEC Electra Elite IPK Programming Manual

Electra Elite IPK
___________________________________________________________________________________

1-16-17 Back Pressure for Half Duplex

General Description
Use this Memory Block to specify whether or not half-duplex Back Pressure Flow
Control is enabled for each HUB(8)-U( ) ETU port.
R1500 or higher is required.
Display
D a t a H U B
N o . 1 ~ 3
1 7 : 1 - 1
T I M E
Settings
LK 1 LK 2
NO YS
Programming Procedures
1 Go off-line.
J J A G
2 Press LK1 + LK16 +
3 Press the corresponding CO/PBX line key to change the option.
G
4 Press to write the data.
5 Repeat steps 3 and 4 for each HUB(8)-U( ) ETU port.
E
6 Press to go back on-line.
___________________________________________________________________________________
Programming Manual
S e t t i n g
P O R T
T i t l e
D a t a
1 ~ 8
B A C K N O
D I S P L A Y
LK 3 LK 4 LK 5
to access the Memory Block.
LK 6 LK 7 LK 8
Document Revision 4
System Mode
1
Submode
16
Data No.
17
PC Programming
+AB
The shaded
selection is the
default.
2 - 413