Automatic Tandem Trunk Assignment - NEC Electra Elite IPK Programming Manual

Document Revision 4
___________________________________________________________________________________
3-06

Automatic Tandem Trunk Assignment

Use this Memory Block to specify the incoming trunk and outgoing trunk for Automatic
Trunk-to-Trunk Transfer.
Display
( I n c o m i n g )
C O / P B X
D a t a
N o .
N o .
( 0 1 ~ 6 4 )
0 1 / 0 6 : T A N D
T I M E
Programming Procedures
G
1 Go off-line.
2 Press LK3 + +
3 Enter the outgoing trunk number for incoming CO/PBX No.
Use the following to enter data:
J
t o move the cursor left
L
t o move the cursor right
K I
~ t o enter numeric data or CO/PBX No.
D
– OR –
G
to go to the next assigned CO/PBX No.
4 Press to write the data and display the next Memory Block.
5 Program the next Memory Block or press
Related Programming
M.B. Number Memory Block Name
3-04 Trunk-to-Trunk Transfer Yes/No Selection
3-05 Trunk Incoming Answer Mode Selection
___________________________________________________________________________________
2 - 432
S e t t i n g
T i t l e D a t a
C O =
D I S P L A Y
K F
t o access the Memory Block.
E
to go back on-line.
Electra Elite IPK
CO/PBX Line Mode
Submode
Data No.
PC Programming
Default Values
Not Specified
Memory Blocks
3
—
06
+AT