Enhanced 911 Dialing Digit Assignment - NEC Electra Elite IPK Programming Manual

Document Revision 4
___________________________________________________________________________________
1-8-46 Enhanced 911 Dialing Digit
Assignment
General Description
Use this Memory Block to specify the number of digits to be sent when a call is
originated by dialing 911.
System Software R2000 or higher is required to assign 9911.
Display
D a t a
N o .
4 6 : 9 1 1
T I M E
Settings
LK 1 LK 2
1 11
Programming Procedures
1 Go off-line.
D F
2 Press LK1 + LK8 +
3 Press the corresponding CO/PBX line key to assign the value.
G
4 Press to write the data. The next Memory Block is displayed.
5 Program next Memory Block or press
Settings
Related Programming
M.B. Number
Memory Block Name
1-8-43 Enhanced 911 Trunk Assignment
1-8-44 Enhanced 911 Alternate Route Assignment
1-8-45 Enhanced 911 Alternate Route Assignment (Maintenance Busy)
1-15-19 Centralized 911 Allow/Deny Selection
1-15-20 Centralized 911 Originating Number Selection
1-15-21 Centralized 911 Look Ahead Routing Allow/Deny Selection
4-54 Enhanced 911 CESID to Station Table
___________________________________________________________________________________
2 - 254
S e t t i n g
T i t l e D a t a
D I A L 9 9 1 1
D I S P L A Y
LK 3 LK 4 LK 5
911 9911
to access the Memory Block.
E
to go back on-line.
LK 6 LK 7 LK8
Electra Elite IPK
System Mode
1
Submode
8
Data No.
46
PC Programming
+AE
The shaded
selection is the
default.
Memory Blocks