NEC Electra Elite IPK Programming Manual page 102

Electra Elite IPK
___________________________________________________________________________________
Programming Procedures
3 Press the corresponding CO/PBX line key to change the tenant number.
Speed Dial buffers have the nine groups listed in the table below.
Speed Dial
Buffer No.
80 Codes
0X
1X
6X
7X
8X
Use the following to enter data:
J
t o move the cursor left
L
t o move the cursor right
K I
C
t o enter numeric data
~
A
to move to the next page
to move to the previous page
Each time a CO/PBX line key is pressed, the LED toggles between On and Off.
CO/PBX
Line LED
Data Restricted
4 Enter all pages for the selected buffer, and press
5 After entering data for the last Speed Dial Buffer No., press
6 Program the next Memory Block or press
Related Programming
M.B. Number Memory Block Name
1-1-33 Speed Dial Number/Name Display Selection
1-1-35 Speed Dial Buffer Allocation
2-01 Trunk to Tenant Assignment
4-09
Telephone to Tenant Assignment
___________________________________________________________________________________
Programming Manual
Speed Dial Number
1000 Codes
00~09 000~099
10~19 100~199
60~69 600~699
70~79 700~799
N/A 800~899
Off On
Not Restricted
E
X = 0~9
The shaded area indicates
the default setting.
G
to write the data and display the next Speed Dial Buffer No.
G
to write that data, and the next Memory Block is displayed.
to go back on-line.
Document Revision 4
Default Values
All System Speed Dial buffers can
be dialed from any tenant.
2 - 25