Enhanced 911 Trunk Assignment - NEC Electra Elite IPK Programming Manual

Electra Elite IPK
___________________________________________________________________________________
1-8-43

Enhanced 911 Trunk Assignment

General Description
Use this feature to define an available loop-start trunk as a CAMA or an ISDN PRI
trunk. When a user dials 911, the system seizes the E911 trunk and sends additional
digits (CESID) to enable the PSAP center to recognize the callback telephone
number. The E911 trunk must be connected to a COI(4)/(8)-U( ), COID(4)/(8)-U( ),
COIB(4)-U( ), or COIB(8)-U( ) Loop Start port and assigned to the system. When the
system is installed at a K-CCIS Remote Office, the Trunk Group or Route Advance
Block that connects to the Main Office is assigned.
System Software R2000 or higher is required to select a Trunk Group or Route
Advance Block.
Display
D a t a
N o .
4 3 : 9 1 1
T I M E
Settings
LK 1 LK 2
CO/PBX TG/RAB
No. No.
Programming Procedures
1 Go off-line.
D C
2 Press LK1 + LK8 +
3 Press Line Key to select CO/PBX No. or TG/RAB No.
Use the following to enter data:
K I
~ t o enter numeric data
J
t o move cursor left
L
H
t o move the cursor right
to clear data
Setting Data: Not Specified (default)
CO No. 01~64
101~132 Trunk Group 01~32
201~232 Route Advance Block 01~32
System Software R1700 and lower only allows CO No. 01~64 to be entered.
G
4 Press to write the data. The next Memory Block is displayed.
5 Program next Memory Block or press
___________________________________________________________________________________
Programming Manual
S e t t i n g
T i t l e D a t a
T R U N K
D I S P L A Y
LK 3 LK 4 LK 5
to access the Memory Block.
E
to go back on-line.
LK 6 LK 7 LK8
Document Revision 4
System Mode
1
Submode
8
Data No.
43
PC Programming
+AE
The shaded
selection is the
default.
2 - 249