Caller Id Preset Dial Outgoing Co Selection - NEC Electra Elite IPK Programming Manual

Document Revision 4
___________________________________________________________________________________
4-44 Caller ID Preset Dial Outgoing CO
Selection
General Description
Use this Memory Block to assign the Trunk group, Route Advanced group, or Closed
Numbering group that is seized for ANI/Caller ID Outgoing Calls. Use the ANI/Caller
ID Scroll key to access the ANI/Caller ID to be called.
Display
T e l
P o r t
D a t a
N o .
~
N o .
( 0 1 C 0 )
0 1 / 4 4 :
T I M E
Programming Procedures
1 Go off-line.
D D
2 Press LK4 +
3 Use the dial pad to enter Trunk Group, Route Advance group, or Closed
Numbering group Access Code to seize for ANI/Caller ID outgoing calls for
Tel Port No.
Use the following to enter data:
J
t o move the cursor left
L
t o move the cursor right
K I
~ t o enter numeric data or Tel Port No.
D
– OR –
B
to go to next assigned Tel Port No.
B A
+
B
B
+
C
G
+
4 Press to write the data and display the next Memory Block.
5 Program the next Memory Block or press
1. Setting Data is Access Code Assignment in Memory Blocks 1-1-46, 47, 48 [Access Code (1-Digit, 2-Digit, or
3-Digit) Assignment]. For example: Dial 9 (101) → Trunk Group 1.
2. Assign the ANI/Caller ID Scroll key using Memory Blocks 2-06 (Line Key Selection for Tenant Mode) or 4-12
(Line Key Selection for Telephone Mode).
3. Telephone ports A0~C0 are ports 100~120. Use redial +1 for A, redial +2 for B, and redial +3 for C.
___________________________________________________________________________________
2 - 558
S e t t i n g
D a t a
D I S P L A Y
to access the Memory Block.
t o enter A for Port Numbers 100~109
t o enter B for Port Numbers 110~119
t o enter C for Port Number 120
E
to go back on-line.
Notes
Electra Elite IPK
Telephone Mode
Submode
PC Programming
Default Value
Not specified
Memory Blocks
4
—
Data No.
44
+AI