Isdn-Bri/Pri Directory Number Checking Selection - NEC Electra Elite IPK Programming Manual

Document Revision 4
___________________________________________________________________________________
3-77 ISDN-BRI/PRI Directory Number
Checking Selection
General Description
Use this Memory Block to determine whether or not the BRT/PRT ETU passes the
Directory Number to the CPU when it is received in the ISDN Set Up message.
Enhancement
R4000 or higher and BRT Firmware 2.05 or higher support DID for ISDN-BRI Trunks.
This allows BRI and DID callers with non-matching SPID Numbers to determine whether the
system checks the called party number with the SETUP message and the SPID setup. When this Memory Block is set to
NO, DID calls can be received on BRI trunks and directed according to Memory Block 1-1-22 (DID Digit Conversion
Table).
Display
C O / P B X
N o . D a t a
( 0 1 ~ 6 4 ) N o .
0 1 / 7 7 : D N
T I M E
Settings
LK 1 LK 2
NO YES
Programming Procedures
G
1 Go off-line.
2 Press LK3 +
Use the following to enter data:
J
t o move the cursor left
L
t o move the cursor right
K I
~ t o enter numeric data or CO/PBX No.
D
– OR –
to go to the next assigned CO/PBX No.
G
3 Press the corresponding CO/PBX line key to change the Setting Data option.
4 Press to write the selected data and display next Memory Block.
5 Program the next Memory Block or press
___________________________________________________________________________________
2 - 496
S e t t i n g
T i t l e
D a t a
C H K
D I S P L A Y
LK 3 LK 4
G G
+ to access the Memory Block.
E
N O
LK 5 LK 6
to go back on-line.
CO/PBX Line Mode
PC Programming
LK 7 LK 8 The shaded
selection is the
default.
Default Values
CO/PBX No. 01~64
Electra Elite IPK
3
Submode
—
Data No.
77
+AN
Memory Blocks