NEC Electra Elite IPK Programming Manual page 493

Document Revision 4
___________________________________________________________________________________
Programming Procedures
1 Go off-line.
2 Press LK2 to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Use the following to enter data:
J
t o move the cursor left
L
t o move the cursor right
K I
D
~ t o enter numeric data
C
to go to the next assigned Tenant No.
A
to go to the next page
to go to the previous page
Data Options:
\
CO/PBX
Line LED
Data
G
4 Press to write the data. The next Memory Block is displayed.
5 Program Memory Blocks 2-05~2-09. The next Tenant No. is displayed.
6 Repeat steps 3, 4, and 5 for each Tenant No. Memory Block 2-01 Tenant 00 is displayed.
E
7 Press to go back on-line.
Related Programming
M.B. Number Memory Block Name
2-05 Line Key Selection
4-09 Telephone to Tenant Assignment
When data is changed while the system is busy, DATA ENTRY is displayed at the programming station until the
system becomes idle.
___________________________________________________________________________________
2 - 416
Off On
No Yes
(Not Assigned) (Assigned)
Notes
Default Values
Tenant 00 = All trunks are assigned
Tenant 01~47 = Not assigned
Electra Elite IPK
Memory Blocks