1-16-11 Mirroring Source Port Assignment - NEC Electra Elite IPK Programming Manual

Electra Elite IPK
___________________________________________________________________________________

1-16-11 Mirroring Source Port Assignment

General Description
When Port Mirroring is enabled in Memory Block 1-16-10 (Port Mirroring Selection),
use this Memory Block to specify a port with data to be monitored on another port
specified by Memory Block 1-16-12 (Mirroring Target Port Assigment) for each
HUB(8) -U( ) ETU. The source port and target port must be in the same VLAN(s).
R1500 or higher is required.
Display
D a t a H U B
N o . 1 ~ 3
1 1 : 1
T I M E
Programming Procedures
1 Go off-line.
J J A A
2 Press LK1 + LK16 +
3 Use dial pad keys to enter Setting Data.
Use the following to enter data:
J
Use t o move cursor left
L
Use t o move cursor right
K I
Use ~
Port range is 1~8.
G
4 Press to write the data.
5 Repeat steps 3 and 4 for each HUB(8)-U( ) ETU.
E
6 Press to go back on-line.
___________________________________________________________________________________
Programming Manual
S e t t i n g
T i t l e
D a t a
S O U R C E = 1
D I S P L A Y
to access the Memory Block.
t o enter numeric data
Document Revision 4
System Mode
Submode
Data No.
PC Programming
Default Values :
Port 1
1
16
11
+AB
2 - 401