NEC Electra Elite IPK Programming Manual page 200

Electra Elite IPK
___________________________________________________________________________________
Display (R3000 or higher)
D a t a
N o . T i t l e
2 2 : N O A N S
T I M E
Programming Procedures
1 Go off-line.
B B
2 Press LK1 + LK2 +
3 Use the dial pad to enter the Data Setting for Class 1.
Setting Data
G
01s~99s (e.g., 05s =5s)
4 Press to write the data and display the next Timer Class of Service.
5 Program the next Timer Class of Service or press
Related Programming
M.B. Number Memory Block Name
1-1-46 Access Code (1-Digit) Assignment
1-1-47 Access Code (2-Digit) Assignment
1-1-48 Access Code (3-Digit) Assignment
1-2-01 Intercom Call Voice/Tone Signal Selection
1-8-08 Class of Service (Station) Feature Selection 2
4-17
Station to Class of Service Feature Assignment
4-42
Call Forward-Busy Immediately/Delay Selection
4-71
Station to Timer Class of Service (R3000 or higher)
1. Telephone Ports 1 and 2 are in Station to Timer Class of Service, Class 1, by default. All other ports are in
Station to Timer Class of Service, Class 2, by default.
2. When a system is upgraded from R2500 or lower to R3000 or higher, the Call Forward – No Answer Time
Selection is reset to the default during the upgrade process.
___________________________________________________________________________________
Programming Manual
T i m e r
C l a s s
S e t t i n g
1 ~ 4
D a t a
1 = 1 2 s
D I S P L A Y
to access the Memory Block.
E
to go back on-line.
Notes
Document Revision 4
Default Values
Class 1~4 = 12s
2 - 123