1-16-09 Low Priority Tx Tag Assignment - NEC Electra Elite IPK Programming Manual

Electra Elite IPK
___________________________________________________________________________________

1-16-09 Low Priority TX Tag Assignment

General Description
For frames marked at the ingress port by Memory Block 1-16-06 as Low Priority, this
memory block setting on the egress port assigns a value (0 ~7) to the priority field of
the VLAN tag. The default is 0.
R1500 or higher is required.
Display
D a t a H U B
N o . 1 ~ 3
0 9 : 1 - 1
T I M E
Programming Procedures
1 Go off-line.
J J K I
2 Press LK1 + LK16 +
3 Use dial pad keys to enter Setting data.
Use the following to enter data:
J
Use t o move cursor left
L
Use t o move cursor right
K I
Use ~
Priority range is lowest 0~7 highest.
G
4 Press to write the data.
5 Repeat steps 3 and 4 for each port.
E
6 Press to go back on-line.
___________________________________________________________________________________
Programming Manual
P O R T
S e t t i n g
1 ~ 8 T i t l e
L O W T X = 0
D I S P L A Y
to access the Memory Block.
t o enter numeric data
D a t a
Document Revision 4
System Mode System Mode
Submode Submode
Data No. Data No.
PC Programming PC Programming
Default Values :
All ports = 0
1 1
16 16
09 08
+AB +AB
2 - 397