NEC Electra Elite IPK Programming Manual page 340

Electra Elite IPK
___________________________________________________________________________________
1-10-00 Call by Call Type of Network ID
Assignment
General Description
Use this Memory Block to send the Type of Number ID (TNI) for each Route Advance
Block (RAB). This setting data is sent in the TNI field of the NSF-IE (Network Specified
Facility-Information Element) when making outgoing calls.
Display
D a t a
R A B
N o .
0 1 ~ 3 2
0 1 / 0 0 : T N I
T I M E
Programming Procedures
1 Go off-line.
2 Press LK1 + LK10 to access the Memory Block.
3 Enter data using the dial pad.
Use the following to enter data:
J L
a nd
K I
D
~ t o enter data
to select next RAB No.
Setting Data:
0, 1 Reserved (Not Used)
2 National Network Identification
3~7 Reserved (Not Used)
G
4 Press to write the data. The next Memory Block is displayed.
5 Program Memory Blocks 1-10-01~09. RAB 2 for this Memory Block is displayed.
6 Repeat steps 3, 4, and 5 for all RABs. After Memory Block 1-10-09 is programmed for RAB 32, Memory Block 1-10-20 is
displayed.
7 Program the next Memory Block or press
___________________________________________________________________________________
Programming Manual
T i t l e
=
D I S P L A Y
t o move the cursor
E
to go back on-line.
S e t t i n g
D a t a
2
Document Revision 4
System Mode
Submode
Data No.
PC Programming
Default Values
All RABS 2
1
10
00
+AY
2 - 263