Occ Table To Trunk Group Assignment - NEC Electra Elite IPK Programming Manual

Document Revision 4
___________________________________________________________________________________
5-03 OCC Table to Trunk Group
Assignment
General Description
Use this Memory Block to assign each of the 16 OCC Tables to each Trunk group.
Display
T r u n k G r o u p
D a t a
N o .
N o .
( 0 1 ~ 3 2 )
0 1 / 0 3 : O C C - T R K G | 1
T I M E
Settings
Page 1
LK 1 LK 2
Table 00 Table 01
Page 2
LK 1 LK 2
Table 08 Table 09
Programming Procedures
G
1 Go off-line.
2 Press LK5 +
3 Press the corresponding CO/PBX line key to enter the data. Operation data includes:
CO/PBX
Line LED
Data
Use the following to enter data:
J
t o move the cursor left
C
L
t o move the cursor right
A
to go to the next page
D
to go to the previous page
G
to go to the next Trunk Group No.
4 Press to write the data and display the next Trunk Group No. for Memory Block 5-00.
Related Programming
Refer to Chapter 3 Advanced
___________________________________________________________________________________
2 - 612
T i t l e
D I S P L A Y
LK 3 LK 4
Table 02 Table 03
LK 3 LK 4
Table 10 Table 11
K C
+ to access the Memory Block.
Off On
Disabled Enabled
Applications.
P a g e
N o .
LK 5 LK 6
Table 04 Table 05 Table 06
LK 5 LK 6
Table 12 Table 13 Table 14
The shaded selection is
the default.
Trunk Group Mode
PC Programming
LK 7 LK 8
Table 07
All are enabled.
LK 7 LK 8
Table 15
Default Values
Use all tables.
Electra Elite IPK
5
Submode
—
Data No.
03
+AC
Memory Blocks