Disa Password Effect/Invalid Selection - NEC Electra Elite IPK Programming Manual

Document Revision 4
___________________________________________________________________________________
1-9-02 DISA Password Effect/Invalid
Selection
General Description
Use this Memory Block to specify whether or not a Direct Inward System Access
(DISA) Password is required. When NO is assigned, the calling party can use the
DISA feature without a DISA Password.
This Memory Block is automatically displayed after data is written for each ID Buffer
No. (01~CO for Electra Elite 192 or 01~48 for Electra Elite 48) in Memory Block
1-9-00. After password selection is entered, the next sequential ID Buffer NO. is
displayed on Memory Block 1-9-00. This cycle is repeated until all DISA ID codes are
assigned, and then cycles back to ID Buffer No. 1. Programming does not
automatically cycle to Memory Block 1-10-00.
Display
I D B u f f e r
N o . D a t a
( 0 1 ~ C O ) N o .
0 1 / 0 2 : P A S W O R D = Y S
T I M E
Settings
LK 1 LK 2
NO YS
Programming Procedures
1 Go off-line.
J B
2 Press LK1 + LK9 +
3 Press the corresponding CO/PBX line key to change the data option.
Setting Data:
NO (LK1) = DISA Password is not required.
YS (LK2) = DISA Password is required. Assign with MB 1-1-46~48 [Access Code (1-,2-, or 3-Digit) Assignment].
G
4 Press to write the data and return to the next Memory Block 1-9-00.
5 After last DISA ID Password decision is made, press
E
6 Press to go back on-line.
Related Programming
Refer to individual features in the Electra Elite IPK Features and Specifications Manual.
___________________________________________________________________________________
2 - 262
S e t t i n g
T i t l e D a t a
D I S P L A Y
LK 3 LK 4 LK 5
to access the Memory Block.
LK 6 LK 7
G
to write the data and return to Buffer No. 01 on Memory Block 1-9-00.
Electra Elite IPK
System Mode
1
Submode
9
Data No.
02
PC Programming
+BD
LK 8 The shaded
selection is the
default.
Memory Blocks