nark
0 4
0 7
0 3
0 2
ENGINE - Cylinder
REMOVAL SERVICE POINTS
(A, INTAKE CAMSHAFT SPROCKET REMOVAL
remove the camshaft sprocket bolt.
Caution
Locking the camshaft sprocket with a tool damages
the sprocket.
(2) Remove the camshaft sprockets.
Using the special tool, remove the cylinder head assembly.
NOTE
Use of commercially available cylinder head bolt wrench is
recommended.
INSTALLATION SERVICE POINTS
(1) Make sure that the gasket has the proper identification
mark for the engine.
(2) Lay the cylinder head gasket on the cylinder block with
the identification mark at the front top.
(1) Use a scraper to clean the gasket surface of the cylinder
head assembly.
Caution
Take care that no foreign material gets into the cylin-
der, coolant passages or oil passages.
(2) Using the special tool and a torque wrench, tighten the
bolts to the specified torque in the order shown in the
illustration (in two or three cycles).
Caution
Install the head bolt washers with shear droop upward
as shown in the illustration.
(3) Back off the bolts once and tighten them to the specified
torque as shown in step (2). <Turbo>
NOTE
Use of commercially available cylinder head bolt wrench
Front
is recommended.
bank
TSB Revision
Head Gasket