Mitsubishi 3000GT Service Manual page 101

Thread diameter x length
992
Thread diameter x Lenclth mm (in.)
12x71 -39
(.39x 1.06)
ENGINE
NOTE
Even if the
tensioner is
tion.
Standard value (A): 3.8-4.5 mm (.149-.177 in.)
If the protrusion is out of specification, repeat steps (1)
to (4).
(5) Check again that timing marks on all sprockets are aligned
properly.
Since the mounting bolts of timing cover are different in size
depending on location, insert them with care.
Reamer bolt Since the mounting bolts of engine support bracket are differ-
ent in size depending on location, insert them in numbered
sequence.
Caution
When installing the reamer bolt, tighten it, slowly spraying
lubricant on the reamer area.
3
Using the special tool, attach the crankshaft pulley to the
crankshaft.
Caution
Use only the specified special tools, otherwise a damaged
pulley damper could result.
Belt
set pin cannot be easily inserted, the auto
normal if its rod protrusion is within specifica-