GENERAL - Maintenance Service
In case that there is a notch on the lock lever (Type
Place a flat tip screwdriver against the lock spring (metal
section) at the lock lever notch as shown in the illustration,
and push the spring toward the unit.
Caution
Do not use excessive force to raise the lock lever.
(4) Disconnect the red 14-pin connector from the SDU.
(1) Remove right and left front splash shield extensions.
Check sensors to ensure the arrow marks face the front
of the vehicle.
(2) Check front upper frame lower and sensor brackets for
deformities or rust.
Caution
The SRS may not activate properly if a front impact
sensor is not installed properly, which could result
in serious injury or death to the vehicle's driver and
7
passenger.
(3) Check wiring harness (for front impact sensor) for binds,
connector for damage, and terminals for deformities.
Replace sensor and/or wiring harness if it fails visual
check. (Refer to GROUP 52B - Service Precautions and
Front Impact Sensors.)
2-2 SRS Diagnosis Unit (SDU)
(1) Check SDU case and brackets for dents, cracks,
deformities or rust.
Caution
The SRS may not activate properly if SRS diagnosis
unit is not installed properly, which could result in
serious injury or death to the vehicle's driver and
passenger.
(2) Check connectors and lock lever for damage, and
terminals for deformities or rust. Replace SDU if it fails
visual check. [Refer to GROUP 528 - SRS Diagnosis
Unit (SDU).]
TSB Revision