Engine mount bracket -
ENGINE - Engine Assembly
REMOVAL SERVICE POINTS
STEERING OIL PUMP DISCONNECTION
Disconnect air conditioning compressor and power steering
oil pump (with the hose).
NOTE
The removed air conditioning compressor and power steering
oil pump should be fastened (by using rope, etc.) in a position
that will not interfere with the removal/installation of the engine
assembly.
Before removing the engine mount bracket installation bolt,
use a chain block or similar arrangement to suspend the
engine assembly (to the extent that there is no looseness
of the chain).
After checking that the cables, hoses, harness connectors,
etc. are all removed, slowly raise the chain block to lift the
engine assembly upward out of the engine compartment.
INSTALLATION SERVICE POINTS
When mounting the engine, check to be sure that the cables,
hoses, harness connectors, etc. are all in the correct position.
Attach the engine mounting bracket so that the arrow mark
on the mounting stopper is in the direction as shown in the
illustration.