Avaya DEFINITY Server CSI Maintenance Manual page 192

Maintenance Commands
Test Type 102
Test Type 105
ISDN Maintenance
ISDN-PRI Test Call
Extension
ISDN-BRI Service
SPID
DS1 Maintenance
DSO Loop-Around
Test Call
Extension
192
Issue 5 October 2002
Test Type 102 tests far end to near end loss by sending:
9 seconds of 1004 Hz tone at 0 dB
1 second of quiet
This cycle is repeated until disconnect; disconnect is forced
after 24 hours.
Test Type 105 tests 2-way loss, gain slope, and C-message and
C-notch noise by sending:
nine seconds of 1004 Hz at -16 dB
one second of quiet
nine seconds of 404 Hz at -16 dB
one second of quiet
nine seconds of 2804 Hz at -16 dB
30 seconds of quiet
one-half second of Test Progress Tone (2225 Hz)
approximately five seconds of quiet
forced disconnect
This field indicates the extension used by far-end ISDN nodes to
place calls to the system, for testing ISDN-PRI trunks between the
far-end and the system.
This field shows if the link associates with the Service SPID. If the
link is associated with the Service SPID. This number is the test
SPID (0 – 99999) (under BRI-SET MO). Otherwise, this field is
blank. Service SPID is used by the system technician to check
building wiring between the switch and the BRI endpoint.
The extension used to set up a DSO loop around connection for
testing non-ISDN DS1 trunks. The DSO Loop-Around Test Call
feature is used primarily for testing DSO channels associated with
non ISDN-PRI trunks. The loop-around is activated by dialing the
test extension number; multiple DSO Loop-Around connections
can be established by placing multiple calls to the loop-around
extension.
555-233-119