Npv Traffic-Map - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 8 Fibre Channel Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

npv traffic-map

To configure a N Port Virtualization (NPV) traffic map, use the npv traffic map command. To disable
this feature, use the no form of the command. This command is only available when the switch is
operating in NPV mode.
Syntax Description
server-interface
fc slot/port
vfc vfc-id
external-interface
Command Default No traffic map. The switch uses automatic uplink selection to select an NP uplink for the server interface.
Command Modes Configuration mode
Command History Release
4.0(0)N1(2a)
Usage Guidelines NPV traffic maps can be configured only in NPV mode.
Examples The following example creates a mapping between server interface vfc1 and NP uplink fc 3/1:
switch(config)# npv traffic-map server-interface vfc 1 external-interface fc 3/1
Related Commands Command
npv enable
show npv status
OL-16599-01
npv traffic-map server-interface {fc slot/port | vfc vfc-id} external-interface fc slot/port
no npv traffic-map server-interface {fc slot/port | vfc vfc-id} external-interface fc slot/port
Specifies the server interface or a range of server interfaces.
Specifies the slot number and port number for a native Fibre Channel
interface.
Specifies a virtual Fibre Channel interface.
Specifies the NP uplink interface or a range of NP uplink interfaces that can
be selected by the server interface.
Modification
This command was introduced.
Description
Enables NPV mode.
Displays the NPV current status.
Cisco Nexus 5000 Series Command Reference
npv traffic-map
8-107