Logging Console - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 7 System Management Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

logging console

Use the logging console command to enable logging messages to the console session.
To disable logging messages to the console session, use the no form of this command.
Syntax Description severity-level
Command Default
None
Command Modes
Configuration mode
Command History Release
4.0(0)N1(1a)
Examples
This example shows how to enable logging messages with a severity level of 4 (warning) or higher to
the console session:
switch# configure terminal
switch(config)# logging console 4
Related Commands Command
show logging console
OL-16599-01
logging console [severity-level]
no logging console
(Optional) The number of the desired severity level at which messages
should be logged. Messages at or numerically lower than the specified level
are logged. Severity levels are as follows:
•
•
•
•
•
•
•
•
Modification
This command was introduced.
Description
Displays the console logging configuration.
0—emergency: System unusable
1—alert: Immediate action needed
2—critical: Critical condition—default level
3—error: Error condition
4—warning: Warning condition
5—notification: Normal but significant condition
6—informational: Informational message only
7—debugging: Appears during debugging only
Cisco Nexus 5000 Series Command Reference
logging console
7-7