Show Running-Config Interface - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

show running-config interface

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
show running-config interface
To display the running configuration for a specific port channel, use the show running-config interface
port-channel command.
Syntax Description all
ethernet slot/port
expand-port-profile
loopback number
port-channel
channel-number
membership
tunnel number
vlan vlan-id
Defaults None
Command Modes
Any command mode
Command History Release
4.1(3)N1(1)
Usage Guidelines
This command does not require a license.
Examples
This example shows how to display the running configuration for port channel 10:
switch(config)# show running-config interface port-channel 10
version 4.0(1)
interface port-channel10
switchport
switchport mode trunk
Related Commands Command
show running-config
Cisco Nexus 5000 Series Command Reference
10-2
show running-config interface [all | {ethernet {slot/port} [all]} | expand-port-profile |
{loopback {number} [all]} | {mgmt0 [all]} | {port-channel {channel-number}
[membership]} | {tunnel {number} [all]} | {vlan {vlan-id} [all]}
Shows configuration with defaults.
Number of the module and port number.
Shows port profiles.
Number of the loopback interface. The range of values is from 1 to 4096.
Number of the port-channel group. The range of values is from 0 to 1023.
Membership of the specified port channel.
Number of the tunnel interface. The range of values is from 0 to 65535.
Number of the VLAN. The range of values is from 1 to 4096.
Modification
This command was introduced.
Description
Displays the running configuration on the device.
Chapter 10 Vpc Commands
OL-16599-01