Show Spanning-Tree Summary - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

show spanning-tree summary

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
show spanning-tree summary
To display summary STP information on the switch, use the show spanning-tree summary command.
Syntax Description
totals
Command Default None
Command Modes EXEC mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines The display output for this command differs when you are running Rapid PVST+ or MST.
Examples This example shows how to display a summary of STP information on the switch:
switch(config)# show spanning-tree summary
Related Commands Command
show spanning-tree
show spanning-tree
active
show spanning-tree
bridge
show spanning-tree
detail
show spanning-tree
interface
show spanning-tree
mst
show spanning-tree
root
show spanning-tree
vlan
Cisco Nexus 5000 Series Command Reference
3-32
show spanning-tree summary [totals]
(Optional) Displays totals only of STP information.
Modification
This command was introduced.
Description
Displays information STP.
Displays information about STP active interfaces only.
Displays bridge ID, timers, and protocol for the local bridge on the switch.
Displays detailed information about STP.
Displays STP interface status and configuration of specified interfaces.
Displays information about MST STP.
Displays status and configuration of the root bridge for the STP instance to
which this switch belongs.
Displays STP information for specified VLANs.
Chapter 3 Ethernet Show Commands
OL-16599-01