Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual page 225

Chapter 2 Ethernet Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
When you use this command without the trunk keyword, the system returns an additional message
similar to the following:
%Portfast has been configured on Ethernet1/40 but will only
have effect when the interface is in a non-trunking mode.
To configure trunk interfaces as spanning tree edge ports, use the spanning-tree port type trunk
command. To remove the spanning tree edge port type setting, use the spanning-tree port type normal
command.
The default spanning tree port type is normal.
Examples This example shows how to configure an interface connected to a host as an edge port, which
automatically transitions that interface to the forwarding state on linkup:
switch(config-if)# spanning-tree port type edge
Related Commands Command
show spanning-tree
OL-16599-01
Description
Displays information about the spanning tree state.
spanning-tree port type edge
Cisco Nexus 5000 Series Command Reference
2-75