Logging Server - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

logging server

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
logging server
Use the logging server command to configure a remote syslog server at the specified host name or
IPv4/IPv6 address.
To disable the remote syslog server, use the no form of this command.
Syntax Description host
severity-level
facility facility
Command Default The default outgoing facility is local7.
Command Modes Configuration mode
Command History Release
4.0(0)N1(1a)
Examples This example shows how to configure a remote syslog server at a specified IPv4 address, using the
default outgoing facility:
switch(config)# logging server 172.28.254.253
Cisco Nexus 5000 Series Command Reference
7-16
logging server host [severity-level] [facility {auth | authpriv | cron | daemon | ftp | kernel | local0
| local1 | local2 | local3 | local4 | local5 | local6 | local7 | lpr | mail | news | syslog | user | uucp}
]
no logging server host
Configure the host name or IPv4/IPv6 address of the Remote Syslog Server.
(Optional) The number of the desired severity level at which messages
should be logged. Messages at or numerically lower than the specified level
are logged. Severity levels are as follows:
•
•
•
•
•
•
•
•
(Optional) Define the appropriate outgoing facility. The facilities are listed
in the
The default outgoing facility is local7.
Modification
This command was introduced.
0—emergency: System unusable
1—alert: Immediate action needed
2—critical: Critical condition—default level
3—error: Error condition
4—warning: Warning condition
5—notification: Normal but significant condition
6—informational: Informational message only
7—debugging: Appears during debugging only
System Message Logging Facilities
Chapter 7 System Management Commands
section.
OL-16599-01