Show Vsan - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

show vsan

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
show vsan
To display information about configured VSAN, use the show vsan command.
Syntax Description vsan-id
membership
interface
fc slot/port
san-port-channel port
vfc vfc-id
usage
Command Default None
Command Modes
EXEC mode.
Command History Release
4.0(0)N1(1a)
Usage Guidelines
When you enter the show vsan membership interface command, interface information is displayed for
interfaces that are configured in this VSAN.
The interface range must be in ascending order and non-overlapping. You can specify a range using a
hyphen and several interfaces using commas:
•
Examples
The following example displays configured VSAN information:
switch# show vsan 1
The following example displays membership information for all VSANs.
switch # show vsan membership
Cisco Nexus 5000 Series Command Reference
9-48
show vsan [vsan-id [membership] | membership [interface {fc slot/port | san-port-channel port
| vfc vfc-id}] | usage]
(Optional) Displays information for the specified VSAN ID. The range is 1
to 4093.
(Optional) Displays membership information.
(Optional) Specifies the interface type.
(Optional) Specifies a Fibre Channel interface.
(Optional) Specifies a SAN port channel interface specified by the port
channel number.
(Optional) Specifies a virtual Fibre Channel interface.
(Optional) Displays VSAN usage in the system.
Modification
This command was introduced.
The interface range format for a Fibre Channel interface range is
fcslot/port - port , fcslot/port , fcslot/port:
For example,
show int fc2/1 - 3 , fc2/4 , fc3/2
Chapter 9 Fibre Channel Show Commands
OL-16599-01