Zone Default-Zone - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 8 Fibre Channel Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

zone default-zone

To define whether a default zone (assigned to nodes not assigned to a created zone) permits or denies
access to all nodes in the default zone, use the zone default-zone command. Use the no form of the
command to negate the command or revert to the factory defaults.
Syntax Description
permit
vsan vsan-id
Command Default All default zones are permitted access.
Command Modes Configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines Use the zone default-zone permit vsan command to define the operational values for the default zone
in a VSAN. This command applies to existing VSANs; it has no effect on VSANs that have not yet been
created.
Use the system default zone default-zone permit command to use the default values defined for the
default zone for all VSANs. The default values are used when you initially create a VSAN and it
becomes active.
Examples
The following example permits default zoning in VSAN 2:
switch(config)# zone default-zone permit vsan 2
Related Commands Command
system default zone
default-zone permit
show zone
OL-16599-01
zone default-zone permit vsan vsan-id
no zone default-zone permit vsan vsan-id
Permits access to all nodes in the default zone.
Sets default zoning behavior for the specified VSAN. The ID of the VSAN
is from 1 to 4093.
Modification
This command was introduced.
Description
Configures default values for a zone.
Displays zone information.
Cisco Nexus 5000 Series Command Reference
zone default-zone
8-149