Show Running-Config Spanning-Tree - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

show running-config spanning-tree

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
show running-config spanning-tree
To display the running configuration for the Spanning Tree Protocol (STP), use the show
running-config spanning-tree command.
Syntax Description all
Command Default
None
Command Modes
EXEC mode
Command History Release
4.0(0)N1(1a)
Examples
This example shows how to display information on the running STP configuration:
switch# show running-config spanning-tree
This example shows how to display detailed information on the running STP configuration:
switch# show running-config spanning-tree all
Display output differs slightly depending on whether you are running Rapid PVST+ or MST.
Note
Related Commands Command
show spanning-tree
Cisco Nexus 5000 Series Command Reference
3-16
show running-config spanning-tree [all]
(Optional) Displays current STP operating information including default
settings.
Modification
This command was introduced.
Description
Displays information about STP.
Chapter 3 Ethernet Show Commands
OL-16599-01