Mac-Address-Table Notification - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 2 Ethernet Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

mac-address-table notification

To configure log message notification of MAC address table events, use the mac-address-table
notification command. To disable log message notifications, use the no form of this command.
Syntax Description
mac-move
threshold
limit percentage
interval seconds
Command Default None
Command Modes Configuration mode
Command History Release
4.0(0)N1(1a)
Examples This example shows how to configure log message notification when the threshold exceeds 45 percent,
restricting the update interval to once every 1024 seconds:
switch(config)# mac-address-table notification threshold limit 45 interval 1024
Related Commands Command
show
mac-address-table
OL-16599-01
mac-address-table notification {mac-move | threshold [limit percentage interval seconds]}
no mac-address-table notification {mac-move | threshold}
Sends a notification message if the MAC address is moved.
Sends a notification message if the MAC address table threshold is exceeded.
(Optional) Specifies the percentage limit (1 to 100) beyond which threshold
notifications are enabled.
(Optional) Specifies the minimum time in seconds (10 to 10000) between
two notifications.
Modification
This command was introduced.
Description
Displays information about MAC address table.
mac-address-table notification
Cisco Nexus 5000 Series Command Reference
2-31