Fcsp Timeout - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

fcsp timeout

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
fcsp timeout
To configure the timeout value for FC-SP message, use the fcsp timeout command. Use the no form of
the command to revert to factory defaults.
Syntax Description
timeout-period
Command Default 30 seconds.
Command Modes Configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines You can only see the fcsp timeout command if you enter the fcsp enable command.
Examples The following example configures the FCSP timeout value:
switch(config)# fcsp enable
switch(config)# fcsp timeout 60
Related Commands Command
fcsp enable
show fcsp
Cisco Nexus 5000 Series Command Reference
8-74
fcsp timeout timeout-period
no fcsp timeout timeout-period
Specifies the time out period. The time ranges from 20 to 100 seconds.
Modification
This command was introduced.
Description
Enable FC-SP.
Displays configured FC-SP information.
Chapter 8 Fibre Channel Commands
OL-16599-01