Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual page 650

Cisco nexus 5000 series command reference, release 4.1(3)n1(1) (ol-16599-01, august 2009)

Hide thumbs Also See for AP775A - Nexus Converged Network Switch 5010:

Table of Contents

member (zone configuration mode)

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

The following example shows how to add a member to a zone called zs1 on VSAN 1:

switch(config)# zone name zs1 vsan 1

switch(config-zone)# member fcid 0x111112

The following example shows how to add a zone to a zoneset called Zoneset1 on VSAN 1:

switch(config)# zoneset name ZoneSet1 vsan 1

switch(config-zoneset-zone)# member fcid 0x111112

The following example shows how to assign a Fibre Channel interface member into a zone:

switch(config)# zoneset name ZoneSet1 vsan 1

switch(config-zoneset-zone)# member interface fc 3/1

The following example shows how to delete the specified device from a zone:

switch(config-zoneset-zone)# no member interface fc 3/1

Related Commands

zoneset (configuration

zone name (zone set

configuration mode)

show zoneset

Cisco Nexus 5000 Series Command Reference

Used to specify a name for a zone set.

Configures a zone in a zoneset.

Displays zone set information.

Fibre Channel Commands