logging timestamp
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
logging timestamp
Use the logging timestamp command to set the logging timestamp units. By default, the units are
seconds.
To reset the logging timestamp units to the default, use the no form of this command.
Syntax Description
microseconds |
milliseconds | seconds
Command Default
None
Command Modes
Configuration mode
Command History
Release
4.0(0)N1(1a)
Examples
This example shows how to set the logging timestamp units to microseconds:
switch(config)# logging timestamp microseconds
Related Commands
Command
show logging
timestamp
Cisco Nexus 5000 Series Command Reference
7-18
logging timestamp {microseconds | milliseconds | seconds}
no logging timestamp {microseconds | milliseconds | seconds}
Selects the units to use for logging timestamps. The default units are
seconds.
Modification
This command was introduced.
Description
Displays the logging timestamp configuration.
Chapter 7
System Management Commands
OL-16599-01