Chapter 5
Quality of Service Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
flowcontrol
To enable IEEE 802.3x link-level flow control for the selected interface, use the flow-control command.
Syntax Description
receive {on | off}
transmit {on | off}
Command Default
None
Command Modes
Interface configuration mode
Command History
Release
4.0(0)N1(1a)
Examples
This example shows how to enable flow control for traffic received on an interface:
switch# configure terminal
switch(config)# interface ethernet 1/2
switch(config-if)# flowcontrol receive on
Related Commands
Command
priority-flow-control
OL-16599-01
flowcontrol [receive {on | off}] [transmit {on | off}]
(Optional) Sets flow control in the receive direction.
(Optional) Sets flow control in the transmit direction.
Modification
This command was introduced.
Description
Sets the PFC mode for the selected interface.
Cisco Nexus 5000 Series Command Reference
flowcontrol
5-3