State - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

state

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
state
To set the operational state for a VLAN, use the state command. To return a VLAN to its default
operational state, use the no form of this command.
Syntax Description
active
suspend
Command Default The VLAN is actively passing traffic.
Command Modes
VLAN configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines You cannot suspend the state for VLAN 1 or VLANs 1006 to 4094.
VLANs in the suspended state do not pass packets.
Examples
This example shows how to suspend VLAN 2:
switch(config)# vlan 2
switch(config-vlan)# state suspend
Related Commands Command
show vlan
Cisco Nexus 5000 Series Command Reference
2-90
state {active | suspend}
no state
Specifies that the VLAN is actively passing traffic.
Specifies that the VLAN is not passing any packets.
Modification
This command was introduced.
Description
Displays VLAN information.
Chapter 2 Ethernet Commands
OL-16599-01