Fex - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

Chapter 4 Fabric Extender Commands
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

fex

To create a Fabric Extender and enter Fabric Extender configuration mode, use the fex command. To
delete the Fabric Extender configuration, use the no form of this command.
Syntax Description
chassis_ID
Command Default None
Command Modes Configuration mode
Command History Release
4.0(1a)N2(1)
Usage Guidelines You can create and configure the Fabric Extender before you connect and associate it to an interface on
the parent switch. Once you associate the Fabric Extender to the switch, the configuration you created
is transferred over to the Fabric Extender and applied.
Examples This example shows how to enter Fabric Extender configuration mode:
switch# configure terminal
switch(config)# fex 101
This example shows how to delete the Fabric Extender configuration:
switch# configure terminal
switch(config)# no fex 101
Related Commands Command
beacon
description (fex)
fex associate
pinning max-links
serial
show fex
OL-16599-01
fex chassis_ID
no fex chassis_ID
Fabric Extender chassis ID. The chassis ID range is from 100 to 199.
Modification
This command was introduced.
Description
Turns on the locator beacon LED of a Fabric Extender.
Specifies a description for a Fabric Extender.
Associates a Fabric Extender to an Ethernet or EtherChannel interface.
Specifies the number of statically pinned uplinks connected to a Fabric
Extender.
Assigns a serial number to a Fabric Extender.
Displays all configured Fabric Extender chassis connected to the switch.
Cisco Nexus 5000 Series Command Reference
fex
4-5