Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual page 630

fspf config
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
Command History Release
4.0(0)N1(1a)
Usage Guidelines
The fspf config command enters FSPF configuration mode for the specified VSAN. In FSPF
configuration mode, the commands configure FSPF for this VSAN .
Examples
The following example configures static SPF computation in VSAN 1 and deletes the FSPF
configuration in VSAN 3:
switch(config)# fspf config vsan 1
switch(fspf-config)# spf static
switch(fspf-config)# exit
switch(config)# no fspf config vsan 3
switch(config)#
Related Commands Command
show fspf interface
fspf enable
fspf cost
fspf hello-interval
fspf passive
fspf retransmit
Cisco Nexus 5000 Series Command Reference
8-82
Modification
This command was introduced.
Description
Displays information for each selected interface.
Enables FSPF routing protocol in the specified VSAN
Configures the cost for the selected interface in the specified VSAN
Specifies the hello message interval to verify the health of a link in the
VSAN
Disables the FSPF protocol for the specified interface in the specified VSAN
Specifies the retransmit time interval for unacknowledged link state updates
in specified VSAN
Chapter 8 Fibre Channel Commands
OL-16599-01