Name (Mst Configuration) - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

name (MST configuration)

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
name (MST configuration)
To set the name of a Multiple Spanning Tree (MST) region, use the name command. To return to the
default name, use the no form of this command.
Syntax Description
name
Command Default
None
Command Modes MST configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines Two or more switches with the same VLAN mapping and configuration version number are considered
to be in different MST regions if the region names are different.
Caution Be careful when using the name command to set the name of an MST region. If you make a mistake,
you can put the switch in a different region. The configuration name is a case-sensitive parameter.
Examples This example shows how to name a region:
switch(config)# spanning-tree mst configuration
switch(config-mst)# name accounting
Related Commands Command
show spanning-tree
mst configuration
spanning-tree mst
configuration
Cisco Nexus 5000 Series Command Reference
2-36
name name
no name name
Name to assign to the MST region. It can be any string with a maximum
length of 32 alphanumeric characters.
Modification
This command was introduced.
Description
Displays information about the MST protocol.
Enters MST configuration mode.
Chapter 2 Ethernet Commands
OL-16599-01