show vpc brief
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
show vpc brief
To display brief information about the virtual port channels (vPCs), use the show vpc brief command.
Syntax Description
vpc number
Defaults
None
Command Modes
Any command mode.
Command History
Release
4.1(3)N1(1)
Usage Guidelines
The show vpc brief command displays the vPC domain ID, the peer-link status, the keepalive message
status, whether the configuration consistency is successful, and whether peer-link formed or the failure
to form.
This command is not available if you have not enabled the vPC feature. See feature vpc for information
on enabling vPCs.
You can display the track object, if you have configured a tracked object for running vPCs on a single
module under the vpc-domain configuration mode. This command does not require a license.
Examples
This example shows how to display brief information about the vPCs:
switch(config)# show vpc brief
Legend:
vPC domain id
Peer status
vPC keep-alive status
Configuration consistency status: success
vPC role
Number of vPC configured
vPC Peer-link status
---------------------------------------------------------------------
id
--
1
vPC status
----------------------------------------------------------------------
Cisco Nexus 5000 Series Command Reference
10-6
show vpc brief [vpc number]
(Optional) Displays the brief information for the specified vPC. The
range is from 1 to 4096.
Modification
This command was introduced.
(*) - local vpc is down, forwarding via vPC peer-link
Port
Status Active vlans
----
------ --------------------------------------------------
Po10
up
1-100
: 10
: peer adjacency formed ok
: peer is alive
: primary
: 1
Chapter 10
Vpc Commands
OL-16599-01