Fcflow Stats - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

fcflow stats

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
fcflow stats
To configure fcflow statistics, use the fcflow stats command. To disable the counter, use the no form of
the command.
Syntax Description
aggregated
index flow-number
vsan vsan-id
destination-fcid
source-fcid
netmask
Command Default
None
Command Modes
Configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines
If you enable flow counters, you can enable a maximum of 1024 entries for aggregate flow and flow
statistics. Be sure to assign an unused flow index or each new flow. The number space for flow index is
shared between the aggregate flow statistics and the flow statistics.
Examples
The following example enables the aggregated flow counter:
switch(config)# fcflow stats aggregated index 1005 vsan 1
The following example disables the aggregated flow counter:
switch(config)# no fcflow stats aggregated index 1005
The following example enables the flow counter for a specific flow:
switch(config)# fcflow stats index 1 0x145601 0x5601 0xffffff vsan 1
The following example disables the flow counter for index 1001:
switch(config)# no fcflow stats index 1001
Cisco Nexus 5000 Series Command Reference
8-54
fcflow stats {aggregated index flow-number vsan vsan-id | index flow-number destination-fcid
source-fcid netmask vsan vsan-id}
no fcflow stats {aggregated index flow-number | index flow-number}
Configures aggregated fcflow statistics.
Specifies a flow index. The range is 1 to 2147483647.
Specifies a VSAN ID. The range is 1 to 4093.
Enters the destination FCID in hexadecimal format.
Enters the source FCID in hexadecimal format.
Enters the mask for the source and destination FCID (restricted to 6
hexadecimal characters ranging from 0xff0000 to 0xffffff).
Modification
This command was introduced.
Chapter 8 Fibre Channel Commands
OL-16599-01