Spanning-Tree Port Type Network - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual
Cisco nexus 5000 series command reference, release 4.1(3)n1(1) (ol-16599-01, august 2009)
Hide thumbs
Also See for AP775A - Nexus Converged Network Switch 5010:
- Configuration manual (1486 pages) ,
- Reference (886 pages) ,
- Release note (26 pages)
Table of Contents
Advertisement
spanning-tree port type network
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
spanning-tree port type network
To configure the interface that connects to a switch as a network spanning tree port, regardless of the
global configuration, use the spanning-tree port type network command. To return the port to a normal
spanning tree port, use the spanning-tree port type normal command or use the no form of this
command.
Syntax Description
This command has no arguments or keywords.
Command Default
The default is the global setting for the default port type network that is configured when you entered
the
default spanning tree port type is normal.
Command Modes
Interface configuration mode
Command History
Release
4.0(0)N1(1a)
Usage Guidelines
Use this command to configure an interface that connects to a switch as a spanning tree network port.
Bridge Assurance runs only on Spanning Tree Protocol (STP) network ports.
Note
If you mistakenly configure ports connected to hosts as STP network ports and enable Bridge Assurance,
those ports will automatically move into the blocking state.
Note
Bridge Assurance is enabled by default, and all interfaces configured as spanning tree network ports have
Bridge Assurance enabled.
To configure a port as a spanning tree network port, use the spanning-tree port type network command.
To remove this configuration, use the spanning-tree port type normal command. When you use the no
spanning-tree port type command, the software returns the port to the global default setting for network
port types.
You can configure all ports that are connected to switches as spanning tree network ports by default by
entering the
The default spanning tree port type is normal.
Cisco Nexus 5000 Series Command Reference
2-82
spanning-tree port type network
spanning-tree port type normal
no spanning-tree port type
spanning-tree port type network default
Modification
This command was introduced.
spanning-tree port type network default
command. If you did not configure a global setting, the
command.
Chapter 2
Ethernet Commands
OL-16599-01
Advertisement
Table of Contents
