Switchport - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual
Cisco nexus 5000 series command reference, release 4.1(3)n1(1) (ol-16599-01, august 2009)
Hide thumbs
Also See for AP775A - Nexus Converged Network Switch 5010:
- Configuration manual (1486 pages) ,
- Reference (886 pages) ,
- Release note (26 pages)
Table of Contents
Advertisement
switchport
S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
switchport
To configure a switch port parameter on a Fibre Channel or virtual Fibre Channel interface, use the
switchport command. To discard the configuration, use the no form of the command.
Syntax Description
encap eisl
fcrxbbcredit
credit
mode
E
F
default
mode
auto
E
F
SD
NP
speed
1000
2000
4000
auto
max 2000
trunk
allowed
vsan
add
Cisco Nexus 5000 Series Command Reference
8-130
Fibre Channel Interface:
switchport { encap eisl |
fcrxbbcredit {credit [mode E | F ] | default | } |
mode {auto | E | F | SD | NP} |
speed {1000 | 2000 | 4000 | auto [max 2000]} |
trunk {allowed vsan {[add] vsan-id | all} | mode {auto | off | on}}}
no switchport { encap eisl | fcrxbbcredit| fcrxbufsize size | mode | rate | speed | trunk allowed
vsan [[add] vsan-id | all]}
Virtual Fibre Channel Interface:
switchport mode F
Configures extended ISL (EISL) encapsulation for the interface.
Configures receive BB_credit for the port.
Specifies receive BB_credit. The range is 1 to 255
Configures receive BB_credit for the specific port mode.
Configures receive BB_credit for E or TE port mode.
Configures receive BB_credit for F port mode.
Configures default receive BB_credits depending on the port mode and
capabilities.
Configures the port mode.
Configures autosense mode.
Configures E port mode.
Configures F port mode.
Configures SD port mode.
Configures N port proxy mode. NP mode is valid only when the switch is
operating in NPV mode.
Configures the port speed.
Configures 1000-Mbps speed.
Configures 2000-Mbps speed.
Configures 4000-Mbps speed.
Configures autosense speed.
Configures 2-Gbps as the maximum bandwidth reserved in auto mode for
24-port and 48-port 4-Gbps switching module interfaces.
Configures trunking parameters on the interface.
Specifies the allowed list for interface(s).
Configures the VSAN range.
(Optional) Adds the VSAN ID to the range of allowed VSAN list
Chapter 8
Fibre Channel Commands
OL-16599-01
Advertisement
Table of Contents
